How To Add PDN Layers HERE. I do it the first way every time. PDN/PSP Plugins that I use a lot are located HERE.

Tuesday, December 3, 2013

On Sleepy Wings

 Supplies Used 

“Wings” by Jose Cano,  HERE
“Nautigal” by Rob,  here
“Fresh Start” by Soxsational Scraps, here
“Mask 62” by Moonbeams & Spiderwebs, here
 Lets' Begin! 

Create a canvas 800x800.

Open paper 2 and apply your mask. Resize by 80% and add to your canvas, center, flip layer vertical and then flip white background.

Save in *psd and name “Fresh Start”.

Open element 29 (double frame) and position this over your mask. 

Open your tube, upsize by 102%, sharpen by 4 and then add to your canvas.

Open element 10 (pink ribbon) and add above your frame layer. Flip white background. Go back to element and use the rotation settings below to set your ribbon. drop with 3-2-0-6-90.

Move the ribbon to one side and duplicate. On each layer, erase one side. Position both to where the look as if they are still connected and merge the two layers together.

Open element 18 and resize by 55%. Add this on the right side of your frame. Flip white background and drop with 3-2-0-6-90. 

Open element 19 (bear) and resize by 35%. Sit him on your chair. Drop with the same settings above but lower your opacity to 60.

Open element 25 and resize by 25% and place under your frame layer, in the left hand window.

Open element 24 and resize by 30% then flip horizontal. Place under your frame layer and last pillow layer, in the left hand window. Run your eraser around the perimeter to eliminate excess.

Open element 5 and resize first by 65%. Move this to the left hand side of your tube layer. Undo this and resize again by 45%. Add this to the right.

Open element 10 and resize by 40% and add this below your last flower layer. Pull upwards and to the left to obscure it somewhat. Undo resize and resize again by 25%. Add this above your chair layer and pull to the right.

Open element 45 and resize by 70%. Add above your tube layer, to the left of the blue flowers. Flip background, then flip horizontal the leaves and drop shadow with 3-2-6-90. Duplicate and flip horizontal again.

On your first leaves layer (by chair), flip vertical and position. Merge the two layers together.

Crop your design to your liking, making sure as to not cut off your mask. Flip white background if needed and drop remaining layers that have not been dropped.

Resize, if needed, and add your copyright. Upload to a photo sharing site and enjoy!

No comments:

Post a Comment