Bunny Eggs

 Brooke 2 by Jose Cano (HERE)

"Happy Bunny Eggs" by TK Designs (HERE)

Sorta Square Mask by BeckyP (HERE)

“South Australia” (NAME)

Create a canvas 1000 x 1000. We can always crop and resize later.

Add ScrapTK_HappyBunnyEggs-frame1 to the canvas and center align.

Use ScrapTK_HappyBunnyEggs-paper1 to fill the frame opening.

Open ScrapTK_HappyBunnyEggs-element16, resize (if needed) and apply the mask. To make this work, follow the prompt below.

Duplicate this layer several times to darken slightly.

Apply the mask again to ScrapTK_HappyBunnyEggs-paper3 and add behind the wire layer.

Open the tube, resize by 65% and add above the frame layer; center align.

Add ScrapTK_HappyBunnyEggs-frame3 below the tube layer and center align.

Use ScrapTK_HappyBunnyEggs-paper9 to fill this frame opening.

Add ScrapTK_HappyBunnyEggs-element5a above all layers.

Add ScrapTK_HappyBunnyEggs-element17 below the second frame layer and remove the excess.

Open ScrapTK_HappyBunnyEggs-element8, resize to 650 widths and add below the tube layer.

Add ScrapTK_HappyBunnyEggs-element15 above the ribbon layer.

Open ScrapTK_HappyBunnyEggs-element1, resize by 75% and add below the eggs layer (right).

Open ScrapTK_HappyBunnyEggs-element12b, resize by 50% and add on either side of the circle frame.

Open ScrapTK_HappyBunnyEggs-element12a, resize by 50% and add on either side of the circle frame.

Open ScrapTK_HappyBunnyEggs-element2, resize by 50% and place between the two flowers (left side).

Add ScrapTK_HappyBunnyEggs-element18 on both sides of the design.

Crop as close as you can to the mask and/or design (without cutting off items), resize (if needed) before adding your name and copyright; upload to enjoy.